column 7 of the hazardous materials table

(1) Numeric provisions. It must not freeze at temperatures above 15 C (5 F). For criteria in determining what is a new lighter design, see 173.308(b)(1). Uranium hexafluoride may be classified under this entry only if the conditions of 173.420(a)(4) and (6) and (d) and 173.421(b) and (d) of this subchapter, and, for fissile-excepted material, the conditions of 173.453 of this subchapter are met. b. 19 For domestic transportation only, the identification number UN1075 may be used in place of the identification number specified in column (4) of the 172.101 table. N43 Metal drums are permitted as single packagings only if constructed of nickel or monel. Column 7 of the 172.101 Hazmat Table lists the special provisions that apply to an individual proper shipping name. N80 Packages consisting of one inner metal can, not over 2.5 kg (5.5 pounds) capacity, packed in an outer wooden or fiberboard box, or a wooden barrel, are authorized and need not conform to the requirements of part 178 of this subchapter. Column 2 specifies the minimum test pressure, in bar (1 bar = 14.5 psig), at which the periodic hydrostatic testing required by 180.605 of this subchapter must be conducted. b. W9 When offered for transportation by water, the following Specification packagings are not authorized unless approved by the Associate Administrator: woven plastic bags, plastic film bags, textile bags, paper bags, IBCs and bulk packagings. authorized by name in the Hazardous Materials Table or have been specifically authorized by name either in the Section 172.101 Hazardous Materials Table or have been assigned a shipping name and hazard class by the Associate Administrator for Hazardous Materials Safety. W8 Vessel stowage category for pyrophoric thorium metal or pyrophoric uranium metal is D as defined in 172.101(k)(4). The provisions of this special provision will be effective until January 2, 2023, unless we terminate them earlier or extend them beyond that date by notice of a final rule in the Federal Register. 1/1.1 The batteries must be securely attached to the interior structure of the cargo transport unit (e.g., by means of placement in racks, cabinets, etc.) 106 The recognized name of the particular explosive may be specified in addition to the type. c. Self-propelled vehicles or equipment that also contain an internal combustion engine must be described using the entries Engine, internal combustion, flammable gas powered or Engine, internal combustion, flammable liquid powered or Vehicle, flammable gas powered or Vehicle, flammable liquid powered, as appropriate. The components may be placed in the same outer packaging provided they will not interact dangerously in the event of leakage. Specification IBCs and FIBCs are to be secured to a pallet. A current copy of CGA pamphlet, CGA C-6 must be available at the facility servicing the life-saving appliance. Each tank car must have a reclosing pressure relief device having a start-to-discharge pressure of 10.34 Bar (150 psig). 113 The sample must be given a tentative approval by an agency or laboratory in accordance with 173.56 of this subchapter. Each IBC may not exceed a maximum net quantity of 1,000 kg: a. Formulations with low nitrocellulose contents and neither showing dangerous properties when tested for their ability to detonate, deflagrate or explode when heated under defined confinement by the appropriate test methods and criteria in the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter), nor classed as a Division 4.1 (flammable solid) when tested in accordance with the procedures specified in 173.124 of this subchapter (chips, if necessary, crushed and sieved to a particle size of less than 1.25 mm), are not subject to the requirements of this subchapter. The quantities of hazardous materials do not exceed those specified in 173.4a of this subchapter; and. No Class 7 label is required to be displayed. The proper shipping name Paint related material, corrosive, flammable may be used for consignments of packages containing Paint, corrosive, flammable and Paint related material, corrosive, flammable in the same package; c. The proper shipping name Paint related material, flammable, corrosive may be used for consignments of packages containing Paint, flammable, corrosive and Paint related material, flammable, corrosive in the same package; and. 45 Temperature should be maintained between 18 C (64.4 F) and 40 C (104 F). The adsorbent or absorbent material shall not meet the definition or criteria for inclusion in Classes 1 to 8; c. The maximum contents of a receptacle shall be 10 kg of ammonia; and. (contains magnesium, magnesium nitrides) in PG II or III may be packaged in sift-proof bulk packagings that prevent liquid from reaching the hazardous material with sufficient venting to preclude dangerous accumulation of flammable, corrosive or toxic gaseous emissions such as methane, hydrogen and ammonia. For UN identification numbers 1327, 1363, 1364, 1365, 1386, 1408, 1841, 2211, 2217, 2793 and 3314, IBCs are not required to meet the IBC performance tests specified in part 178, subpart N, of this subchapter. Column 7: Special provisions. B13 A nonspecification cargo tank motor vehicle authorized in 173.247 of this subchapter must be at least equivalent in design and in construction to a DOT 406 cargo tank or MC 306 cargo tank (if constructed before August 31, 1995), except as follows: a. Packagings equivalent to MC 306 cargo tanks are excepted from the certification, venting, and emergency flow requirements of the MC 306 specification. Navigate by entering citations or phrases An unused lighter or a lighter that is cleaned of residue and purged of vapors is not subject to the requirements of this subchapter. TP20 This hazardous material must only be transported in insulated tanks under a nitrogen blanket. A51 For aircraft batteries, irrespective of the quantity limitations specified in Column (9A) of the 172.101 Table or 175.75(c), wet cell batteries, UN2794 or UN2795, up to a limit of 100 kg net mass per package may be transported aboard passenger aircraft. 16 This description applies to smokeless powder and other solid propellants that are used as powder for small arms and have been classed as Division 1.3C, 1.4C and Division 4.1 in accordance with 173.56 of this subchapter. Please do not provide confidential IBCs of type 31A and 31N are only authorized if approved by the Associate Administrator. 2 This material is poisonous by inhalation (see 171.8 of this subchapter) in Hazard Zone B (see 173.116(a) or 173.133(a) of this subchapter), and must be described as an inhalation hazard under the provisions of this subchapter. Others such as copper and silver are available in trace amounts. Dry sodium cyanide or potassium cyanide is also permitted in siftproof, water-resistant, fiberboard IBCs when transported in closed freight containers or transport vehicles. TP7 The vapor space must be purged of air by nitrogen or other means. quantity (RQ)", contains the reportable quantity (RQ), in pounds and kilograms, for each hazardous substance listed in Column 1 of TABLE 1. 347 Effective July 1, 2011, for transportation by aircraft, this entry may only be used if the results of Test series 6(d) of Part I of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter) have demonstrated that any hazardous effects from accidental functioning are confined to within the package. For the regulatory description of the codes for special provisions, please refer to 49 CFR 172.102. b. Symbol Meaning Which is the correct column for hazardous materials? The packaging shall be designed for a working temperature of at least 121 C (250 F). 117 If shipment of the explosive substance is to take place at a time that freezing weather is anticipated, the water contained in the explosive substance must be mixed with denatured alcohol so that freezing will not occur. B30 MC 312, MC 330, MC 331 and DOT 412 cargo tanks and DOT 51 portable tanks must be made of stainless steel, except that steel other than stainless steel may be used in accordance with the provisions of 173.24b(b) of this subchapter. These mixtures may be classified in Division 4.1 when tested in accordance with test series 6(c) of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter) and approved by the Associate Administrator. A105 a. Table 2 defines IP Codes on the use of IBCs that are assigned to specific commodities in the 172.101 Table of this subchapter. 38 If this material shows a violent effect in laboratory tests involving heating under confinement, the labeling requirements of Special Provision 53 apply, and the material must be packaged in accordance with packing method OP6 in 173.225 of this subchapter. formatting. When a plus sign is assigned to mix- 57 Maneb or Maneb preparations stabilized against self-heating need not be classified in Division 4.2 when it can be demonstrated by testing that a volume of 1 m3 of substance does not self-ignite and that the temperature at the center of the sample does not exceed 200 C, when the sample is maintained at a temperature of not less than 75 C 2 C for a period of 24 hours, in accordance with procedures set forth for testing self-heating materials in the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter). 125 Lactose or glucose or similar materials may be used as a phlegmatizer provided that the substance contains not less than 90%, by mass, of phlegmatizer. W41 When offered for transportation by water, this material must be packaged in bales and be securely and tightly bound with rope, wire or similar means. 79 This entry may not be used for mixtures that meet the definition for oxidizing gas. The chemical under pressure must be classed based on the hazard characteristics of the components in the propellant; the liquid; or the solid. In addition, the material also must be covered with an inert gas or the container must be filled with water to the tank's capacity. Refinement of the crystal structure of 5,7,12,14-tetrahydro[2,3-b Except for transportation by aircraft, as an inner packaging of a combination packaging with a maximum net mass of 40 kg (88 pounds). guide. TP26 The heating device must be exterior to the shell. While columns 8 and 7 of the Hazardous Materials Table are used to determine authorized packaging for most HazMat (more on that in a little bit), some methods of transportation, HazMat quantities, and specific operations rely on other methods. c. The equipment, and machinery or apparatus articles conforms with 173.222 of this subchapter.